We can supply bollards up to 300mm square and 3.0 meters long. The timbers we supply are Cypress pine, un-seasoned SpottedGum and Iron Bark. The most used timber for bollards is CYPRESS PINE, due too its class 2 below ground rating, low shrinkage rate of 2.9% and its natural resistance to white ants.
Bollard tops can be made in many different shapes and sizes. The size of a chamfered top is most commonly 20mm and a pyramid top is set at 35deg, but this is only a guide. We can manufacture your bollard tops to almost anyshape and size, to meet your specifications.
Collar sizes vary from job to job, the same as the bollard tops. We have manufactured them from 4mm to 110mmwide and up to 25mm deep, but the most common size is 18mm wide by 10mm deep and the most commonshape is square. Because each job is unique, we have the experience to help you create any shape you require.
We can drill your Chain, pipe or cable holes up to 85mm. Through bollards up to 300mm square or round. We recommend the hole size for pipe, be 5mm bigger than the outside diameter of the pipe required and 4mm bigger for chain and cable.
Impact protection holes are widely used in bollards along road sides parks and reserves to lessen the impact of a vehicle collision. They are usually accompanied by delineators recessed 10mm into the bollards to prevent vandalism. Red delineators on the approach side and white the opposite side.
Where scalloped edges are more for decorative purposes. Chamfering the edges of a bollard, also makes a bollard more user friendly by alleviating sharp corners and splinters.
